• 1 Post
  • 6 Comments
Joined 1 year ago
cake
Cake day: June 18th, 2023

help-circle



  • The case is basically fully metal, just a bit of plastic inside for mounting the PCB to and a few other bits of plastic outside. Plus there is a temperature fuse in the case also.

    From the resistor size (11.5 x 4.5mm) I think it would have been a 2W resistor when comparing to sizes on Digikey. I made a 500 Ohm 2W resistor from 8 1/4W 1K resistors then put a larger resistor in parallel to that to bring it down, measured it to 489 Ohms.

    I’m going to run it a few times then open it up again to see if there is any new damage to the board before returning it.